OPTIONS AVAILABLE:
ST:712 SPUD WELLS
12" diameter spud wells
ST:10" SPUDS
20'ers, and 40'ers
ST:718 SPUD WELLS
18" diameter spud wells
ST:16" SPUDS
20', 40', 50', and 60'
ST:724 SPUD WELLS
24" diameter spud wells
ST:22" SPUDS
20', up to 80'
ST:1012 RAMP
10' Wide by 12' Long
ST:1016 RAMP
10' Wide by 16' Long
ST:05 LADDERS
ST:05 TOW BITTS
ST:05 HAND RAILS
ST:05 12"x6" ZINC'S
ST:05 PAINTED PINS
ANTIFOULANT BOTTOM PAINT RED OR BLUE
SHAKERTON
ST: SERIES SECTIONAL BARGES
Standard Specifications:
All 1/4" A-36 steel plate hull with solid one piece tops, bottoms, sides, and ends.
That's right!! PREMIUM 10' wide one piece tops and bottoms.
3"x3"x1/4" angle transverse truss frames spaced 18" apart.
The connector angles are 6" x 4" x 5/8" welded solid to the hull.
Connector holes are 1.75" dia. spaced 24" O.C. around the entire section.
All holes are drilled not punched, nor burnt with a torch.
The hull is welded solid inside with hard wire mig and the framing is skip welded.
The outer hull is welded with 70-24 5/32nd jet rod and all vertical corners are welded with 70-18 1/8th vertical up hill.
Each SHAKERTON Section is air tested to 5 lbs. psi.
The outer hull is sand blasted and coated with Bar Rust 235 in Haze Gray.
All Sections come with 1-18" flush mounted access hatch, and
all 1.5" double headed connector pins needed.
ST: SERIES Size Weight Empty Draft Deck Loads