J&J BOATWORKS,INC.

30'x12'x3' J-BOAT

OPTIONS AVAILABLE:

MOTOR GUARD:

REMOVABLE HAND RAILS:

FORMED STEEL RUB
RAILS:

4'X4'X7.5' STEEL PILOT HOUSE:
 
4'x6' RISER PLATFORM
WITH HAND RAIL
    12"-18"-24" TALL:       


10- 6"X12" WELD ON ZINC'S:

6" SPUD WELLS
ROUND OR SQUARE:


CUSTOM SPUD WELLS:

2-2 TON DECK WINCHES INSTALLED:

ANTIFOULANT BOTTOM PAINT HALF WAY UP IN : RED OR BLUE

CRANE PEDESTAL FOR
AUTO CRANE:

4004EH AUTO CRANE
INSTALLED:
    

6006EH AUTO CRANE
INSTALLED:
    
CALL ME FOR PRICES AND
AVAILABILITY ON
ALL OUTBOARD INQUIRIES.
We Offer All Boats
Turn Key with
Yamaha Four stroke
Outboards






30'x12'x3' J-BOAT
Only The Best Is Good Enough.

The standard specs are as followed:
All 1/4" A-36 steel plate hull with 3"x3"x1/4" angle framing spaced 18" apart longitudinal. Transverse buck frames, made of the same angle, are spaced 5' apart. This boat comes standard with a collision bulk head set back 10' from the head log. The stern plate and sides have a single angle stiffener set at the centerline at 18". The bow is set with a 48" rake and comes with a 12" tall head log that is 1/2" thick plate. The hull is welded solid inside with hard wire mig and the framing is skip welded. The outer hull is welded with 70-24 5/32nd jet rod and all vertical corners are welded with 70-18 1/8th vertical up hill. The outer hull is sand blasted and coated with Bar Rust 235 in Haze Gray.

This Standard boat comes with 2-18" flush mounted access hatches, 4-18" solid steel kevels (cleats),pair of 36" tall push knees if needed, a steel control stand, and outboard motor bracket or twin brackets.

This hull with standard options weighs in at 13,000 lbs and draft empty at approximately 10".
This hull has a maximum deck load capacity ranging from 8,000-12,000 lbs. These weight calculations are depending on engine size and boat options along with the actual size and weight of deck load.
In all regards to weight loads and stability, make sure you are comfortable transporting what is loaded on the boat and be safe at all times. Remember that the owner of the boat is responsible for any and or all damages that may arise from overloading or underestimating the weight of the load.

This boat is another common size sold and I usually have at least 2 or 3 in stock at all times.
It can come in 2 widths of 11'5" so we can add rub rail, or 11'11" with no rub rails. The ones I build for stock are usually 11'5" wide.
Take a look at the picture set below and if you see any options in the pictures not listed let me know and I will price it out. Thanks and I look forward to hearing from you soon.

Joe Breeck
J&J BoatWorks, Inc.














Website Builder